Moderator: GnATTERbox Moderators
Ken Hamilton wrote:....a fine solution, Gavin! Quick question: How do those little
Bachmann Davenports run? I haven't even powered mine up yet.
Do they run relatively smoothly?
Will Vale wrote:They're very good runners in my (limited) experience. Maybe with a bit of a waddle from the rods and counterweights, but that just adds to the effect.
Ken Hamilton wrote:...another direction for this un-thought-out, build-as-you-go project:
I'm can't stop thinking this in-line 4-cylinder motor is going to
look too high, no matter how I disguise it.
My new thought is to build a flathead V8 onto the styrene "dome".
That would cut down on the height considerably and make the oversized
"crankcase" much easier to hide.
Anybody want to chime in with thoughts...????? Thanks.
Users browsing this forum: No registered users and 13 guests