Moderator: GnATTERbox Moderators
Arthur Inch wrote:Hi Tom,
Well my bargain of a couple of pounds from eBay turned up today, literally as bought............
Arthur Inch wrote: Then couple of hours later..................... after a razor saw, knife, file and a few pieces of plastic card, and a short length of brass tube.
Still needs larger front and rear buffer beams, and a skirt on both sides would improve it's appearance.
Requires going over with wet & dry when the glue dries, otherwise it's a bit rough and ready, but the general gist can be seen of what can be done with a little imagination, small quantities of materials, and just a few hand tools.
As for the chassis itself, only given a clean up, dab of grease, and about 10 minutes running around.
Does need a little more TLC to improve the performance, with hindsight was perhaps not the best choice of a body, never the less, all in all not that bad for a blind purchase!
kf4mat wrote: If mine ever shows up we will see what I can do with it. Can't say it will be worth a crap as it will be my first attempt at something like this but you have to start somewhere.Tom
Users browsing this forum: No registered users and 13 guests