How tight a plain circle??

[Bill Reynolds]

Hello, I want to try a Gn15 layout with a simple circuit to start with. My made up base board is four foot long by two foot wide. I have some Peco 00 flexible track to use. Can someone tell me a size radius circle to fit this size. I would be running 0-4-0 locomotives and short rolling stock on 00 scale wagon bogies.

[Gavin Sowry]

Tree001.jpg (78.46 KiB) Viewed 5094 times

Check out my Haywards Estate Railway....... 8" radius curves.

[tebee]

Couplings are usually the limiting factor - it's the sideplay on these that limits the curve you can get round.

Sideplay is made worse the further the ends of the vehicle are from the wheels, so that is a factor too.

Tom

[southpier]

go as large as you can for reliability and tight as you can for novelty. but novelty is a short lived victory, and if your railroad won't operate you'll lose interest and never finish it.

so, 24" / 2 (assuming your intent is continuous running roundy-round) = 12" radius. that leaves you half-a-track hanging over the board at the ends of both curves which isn't so good for reliable operation either. crunch it in to 10 1/2" radius (measured to track center) and you should have the best of both whirls.

[Bill Reynolds]

Hello Modellers, Thanks for the replies to my question. I had a look at the New Zealand Haywards Heath? line... but no pictures only some computer advert asking me to join Photo Bucket??...As I am not very computer savvy I did not try. I looked at the other end of the messages of this line and found nice photos....Did/Has Photo Bucket 'gone west'...?! I had to ask these questions as for the last fifteen years plus I have been doing 7/8" scale which is another thing. I think a 10. 1/2" radius will have to do on my fledgling Gn18 line, maybe a six inch extra bit of Sundeala bolted onto my base board to make the width 2' 6" wide so I can have a 'main line' along the front of the circuit for a two connection's, one to the 'Reynitium' mine and one to the jam factory....??!

[Thorness]

Hi Bill,

A few months ago Photobucket decided they were no longer going to continue the free hosting service and were demanding money (about $40 a month I think) to continue. A lot of forums of all types were affected and I think most people have moved elsewhere but it means all the old links are now useless.
Stockers ( one of the moderators) has been trying to recover pictures where possible and has put the at the end of the threads.

Cheers

[Bill Reynolds]

Thank Don for the information about Photobucket, very much the same happened to a free Web site hosting service operated by Orange. My site there had around 55 thousand hits, but then Orange decided people had to pay for hosting....I don't know how many people accepted those terms or walked away like I did?!

[Gavin Sowry]

Hello Modellers, Thanks for the replies to my question. I had a look at the New Zealand Haywards Heath? line... but no pictures only some computer advert asking me to join Photo Bucket??...As I am not very computer savvy I did not try. I looked at the other end of the messages of this line and found nice photos....Did/Has Photo Bucket 'gone west'...?! I had to ask these questions as for the last fifteen years plus I have been doing 7/8" scale which is another thing. I think a 10. 1/2" radius will have to do on my fledgling Gn18 line, maybe a six inch extra bit of Sundeala bolted onto my base board to make the width 2' 6" wide so I can have a 'main line' along the front of the circuit for a two connection's, one to the 'Reynitium' mine and one to the jam factory....??!

Pop back and have a look at Haywards Estate Railway.... some/most of the photos have been 'restored'.

DSCF1071.JPG (715.13 KiB) Viewed 4123 times